Operator`s manual

ASSEMBLY
RC12 03/09 Assembly Section 3-6
© 2009 Alamo Group Inc.
ASSEMBLY
ATTACHING AXLE ASSEMBLIES TO MAIN WHEEL BAR TUBE
1. Mark desired row spacing with chalk on wheel bar. Keep outer axle assemblies as close to each end of the
shredder to balance load and prevent scalping. Fasten axle assemblies (item 1) to wheel bar (item 2) with
clamp plate (item 3) and four 3/4" bolts (item 4), lockwashers and nuts (items 5,6). Tighten bolts evenly
and progressively torque to 200 ft. lbs. RC12 is shipped standard with two Axle Assemblies.
2. Attach ratchet screw jack, (Rhino p/n 00554600P) between cylinder bracket mount and ear on rear of
center plate.