Operator`s manual
MAINTENANCE
RC12 03/09 Maintenance Section 5-3
© 2009 Alamo Group Inc.
MAINTENANCE
To lubricate telescoping section of driveline, disconnect yoke from tractor and compress driveline until both
slots on shields are aligned and grease fitting is exposed. Lubricate both u-joints before re-attaching to tractor.
Inspect shields to ensure they rotate freely, replace bearings or shield if damaged.
ROUTINE MAINTENANCE
Inspect belt drive for correct tension and remove
any debris from inside belt shields. Incorrect
tension will result in premature belt failure. Check
belt tension after first hour of operation. Mnt-FL-
0029_A.
Inspect for and tighten any loose fasteners.
Routinely inspect cutter shaft for missing or worn
knives. Replace knives as outlined in Blade
Replacement Procedure, Maintenance Section,
page 5-4.
Clear any debris from gear box area, to prevent
overheating. Clean area around breather plug
regularly.
Always ensure all hitch pins and clips are locked in
place before operation.
Inspect bearing assemblies to ensure locking
collars are locked in place.
All shielding must be in place before operating
shredder. Inspect front rubber shield for wear and
replace if necessary.