Operator`s manual

OPERATION
RC12 03-09 Operation Section 4-11
© 2009 Alamo Group Inc.
OPERATION
8.1 Driveline Length Check
Before operating the Implement, check to make sure the Implement input driveline will not
bottom out or become disengaged. Bottoming out occurs when the inner shaft penetrates
the outer housing until the assembly becomes solid-it can shorten no more. Bottoming out
can cause serious damage to the Tractor PTO by pushing the PTO into the Tractor and
through the support bearings or downward onto the PTO shaft, breaking it off. A broken
driveline can cause personal injury.
(S3PT-18)
Driveline Clearance.
Pull Type Units - After adjusting drawbar to correct
length and attaching mower, check driveline for
telescoping clearance. Before engaging PTO
ensure driveline does not bottom out during sharp
turns. Check vertical clearance between driveline
and hitch pin. Driveline should have a minimum
overlap of 5” at all times.
Disengage the driveline from the tractor PTO
shaft.
Slide the driveline together until it “bottoms out”
solidly.
Apply colored tape to the inner shield 1/8” from
the end of the outer shield.
Reattach the driveline to the PTO shaft. OPS-F-0001_A
Driveline may bottom out or come in contact with hitch while traveling over uneven terrain.
A loose driveline could slip off and result in personal injury or damage to shredder. When
attaching driveline yoke to tractor PTO shaft, it is important that spring-activated locking
collar be seated in groove on PTO shaft.
9. PRE-OPERATION INSPECTION AND SERVICE
Before each use, a pre-operation inspection and service of the implement and tractor must be performed.
This includes routine maintenance and scheduled lubrication, inspecting that all safety devices are equipped
and functional, and performing needed repairs. DO NOT operate the unit if the pre-operation inspection
reveals any condition affecting safe operation. Perform repairs and replacement of damaged and missing
parts as soon as noticed. By performing a thorough pre-operation inspection and service, valuable down time
and repair cost can be avoided. OPS-U-0029
Always disconnect the main PTO Driveline from the Tractor before performing service on
the Implement. Never work on the Implement with the tractor PTO driveline connected and
running. Rotating Parts, Blades or Drivelines could turn without warning and cause
immediate entanglement, injury or death.
(S3PT-11)