Technical data

- 22 -
3. MAINTENANCE
WolfPac 3100/WolfPac 3100R/WolfPac 3100D
3.3 ROLL OVER PROTECTIVE STRUCTURES
(ROPS)
Proper inspection and maintenance procedures can
ensure that the ROPS will perform the lifesaving
function they are designed for and expected to do.
Make regular, periodic inspections to ensure that the
ROPS are damage-free and thus capable of functioning
in an upset.
Generally ROPS structures are not intended as external
load carrying members and must not be used to mount
attachments such as pull hooks, winches, side brooms,
etc. without the manufacturers approval.
Modifications to basic design should be avoided as
recertification is required.
3.3.1 Inspection/Maintenance of ROPS/Seat Belts
Scheduled, frequent visual checks of mounting
hardware by the operator or service personnel are
recommended. Inspection with regular service intervals
is suggested. During the inspection check for the
following:
 Worn, damaged, or missing resilient mounts.
Excessive motion or rattling during operation
are indications of a problem.
 Loose, missing, or damaged mounting
hardware (bolts, nuts, washers, etc.). Bolts
should be checked for proper torque.
 Cracks in ROPS structure and mounting
system. The machine should be cleaned, as
necessary, to allow inspection for cracks in the
structure and mounting system. Rust lines
should be taken as indications of cracks and
verified by inspection. Some cracks will badly
affect the ROPS function. If in doubt, consult
the manufacturer.
 Corrosion. Extensive paint peeling and rust
should be noted and corrective action taken.
 Seat belt. The presence and operability of a
seat belt should be noted. The belt should be
clean, free of dirt and grease, and the latch
should function smoothly. The structure
should be inspected following a roll over,
collision, or fire.
DO NOT REPAIR, MODIFY, OR ADD
ATTACHMENTS TO ROPS UNLESS
AUTHORIZED IN WRITING BY THE
MANUFACTURER.
3.4 ADDITIONAL SERVICE INFORMATION
This is not a detailed engine service manual. If you
want more detailed service information refer to engine
manuals:
 56237 Manual Engine Gx610/Gx620
 56238 Manual Shop Gx610/Gx620
 Kubota Diesel Engine Owners Manual
(provided with WP3100D)
BEFORE MAKING ANY ADJUSTMENTS, BE
SURE THE ROLLER IS PARKED ON LEVEL
GROUND, PARKING BRAKE IS ON AND
DRUMS ARE BLOCKED. DISCONNECT
BATTERY TO AVOID ACCIDENTAL IGNITION
OF ENGINE. SEVERE PERSONAL INJURY
MAY OCCUR.
IMPORTANT: Read Honda or Kubota Emission
Warranty Statement and Engine Manual before
operating or performing maintenance.
3.5 FUEL FILTER
Clean fuel filter pot on Kubota engine to prevent dirt
intrusion. Remove the Honda control cover and inspect
fuel filter, replace if water or dirt sediment is found. In-
line filter should be replaced at scheduled maintenance.
3.6 FUEL TANK
Drain and flush the fuel tank yearly.
WARNING
WARNING