User manual

KVM over IP Module
10 / 99
Using IP-KVM, administrators can determine which kind of serious hardware failure has occurred
Type of failure Detected by
Hard disk failure Console screen, CMOS set-up information
Power cable detached, power supply
failure
Server remains in power off state after power on
command has been given.
CPU Controller, main board failure. Power supply is on, but there is no video output.
CPU fan failure By server specific management software
RAM failure Boot-Sequence on boot console
2.6 Installation
Please follow the following steps:
1. Power down your KVM switch
2. Slide in the module into the module slot of the KVM switch, making sure the module is
inserted firmly into the backplane. Screw and secure the module on the KVM metal panel.
3. Connect Ethernet cable to Ethernet port.