User Manual

ManualsBrandsServer ManualsKitchenPUMPS

PUMP MANUAL 01662-REVB-102813

GAGING COLLARS (Portion Control)

KNOBS

LOCKING COLLAR

HEAD TUBES

HEAD INSERT

SPRINGS

WASHER

PISTONS

SEAL ASSEMBLY

SEAL

SEAL O-RING

LIDS

CYLINDERS

VALVE BODIES

DISCHARGE TUBES

DISCHARGE

TUBE NUT

DISCHARGE TUBE O-RING (1” D)

Smaller gaging collar added

will reduce portion served

by .25 oz, larger by .50 oz

SILICONE GASKET

Go to server-products.com for parts breakdowns and translations

PARTS INCLUDED VARY DEPENDING ON PUMP

Summary of content (4 pages)

PAGE 1
PUMP MANUAL 01662-REVB-102813 Go to server-products.com for parts breakdowns and translations PARTS INCLUDED VARY DEPENDING ON PUMP KNOBS LOCKING COLLAR GAGING COLLARS (Portion Control) Smaller gaging collar added will reduce portion served by .25 oz, larger by .
PAGE 2
CLEAN-IN-PLACE PROCEDURE FOR PUMPS CLEAN-IN-PLACE IS A BASIC FOUR STEP PUMP FLUSHING PROCESS: CLEAN, RINSE, SANITIZE, AND RINSE. CLEAN: 1 PUMP OUT ALL (IF ANY) REMAINING FOOD PRODUCT FROM INSIDE PUMP. 2 3 WASH AND RINSE OFF OUTSIDE OF PUMP. PUMP DISASSEMBLY BEFORE FIRST USE AND AFTER USE DAILY, DISASSEMBLE AND CLEAN PUMP. 1 PUMP OUT ALL (IF ANY) REMAINING FOOD PRODUCT FROM INSIDE PUMP BODY. 2 3 WASH AND RINSE OFF OUTSIDE OF PUMP BODY.
PAGE 3
PUMP ASSEMBLY BEFORE FIRST USE AND AFTER USE DAILY, DISASSEMBLE AND CLEAN PUMP. ASSEMBLE PLUNGER Apply Food Equipment Lubricant onto Seal and Seal 0-Ring ASSEMBLE PLUNGER: 1 INSTALL SEAL O-RING INSIDE SEAL. 2 INSTALL SEAL ASSEMBLY ONTO PISTON HEAD. 3 4 5 INSTALL WASHER ONTO THREADED END OF PISTON. • Apply food equipment lubricant on seal o-ring. • Apply food equipment lubricant inside seal assembly. INSTALL SPRING ONTO THREADED END OF PISTON. INSTALL HEAD INSERT INSIDE HEAD TUBE.
PAGE 4
TROUBLESHOOTING PROBLEMS WITH PUMP OPERATION AND/OR FLOW: • Clean pump. PUMP DISPENSES LITTLE OR NO PRODUCT. • Product may be too stiff or contain a solid that will not pass through pump. PORTION CONTROL IS NOT CONSISTENT. • Inspect gaging collar for any damage and/or proper installation. PUMP PLUNGER DOES NOT RETURN TO TOP OF STROKE AFTER DISPENSING PRODUCT. • Inspect spring for any damage; bent or broken. Replace spring if necessary. PUMP DRIPS. • Clean discharge tube with supplied cleaning brushes.