01725-REVG_071713_BOX_ENGLISH MODEL: ECD EXTREMETM COUNTERTOP DISPENSER Series 07H 07500
SAFETY GUIDELINES According to food and safety regulations, most foods must be stored and/or served at certain temperatures or they could become hazardous. Check with local food DQG VDIHW\ UHJXODWRUV IRU VSHFL¿F JXLGHOLQHV Be aware of the product you are serving and the temperature the product is required to maintain. Server Products, Inc. can not be responsible for the serving of potentially hazardous product. Server Products Inc. claims no responsibility for actual serving temperature of product.
UNIT SET-UP PORTION CONTROL Portion control is the amount of product which will dispense from pump with each full push of lever. The roller, which is attached to the bottom of the lever, FDQ EH DGMXVWHG WR DOORZ IRU VSHFL¿F SRUWLRQ FRQWURO How to Set Portion Control REMOVE LID FROM UNIT. DETERMINE WHICH PIVOT HOLES IN LEVER WILL BE USED TO HOLD ROLLER FOR PORTION DESIRED PER FULL PUSH OF LEVER. REMOVE ROLLER FROM LEVER BY PULLING HINGE PIN OUT.
PUMP DISASSEMBLY REMOVE O-RING FROM CONNECTOR. • &DUHIXOO\ SU\ R ULQJ RII ZLWK ¿QJHUV Do not use a tool or any sharp object to remove o-ring, this will damage the o-ring. REMOVE CONNECTOR FROM FLEXIBLE PLASTIC TUBE. • Rotate and pull connector away from ÀH[LEOH SODVWLF WXEH ALWAYS CLEAN PUMP THOROUGHLY BEFORE EACH USE. SEE UNIT TAKE-DOWN, PUMP DISASSEMBLY, PUMP ASSEMBLY, SAFETY GUIDELINES, AND CLEANING. REMOVE PUMP DOME FROM PUMP HOUSING.
PUMP CLEANING BEFORE FIRST USE DISASSEMBLE AND CLEAN PUMP. SEE UNIT TAKE DOWN. FLUSH AND RINSE PUMP IN A CONTAINER OF WARM WATER. • %H VXUH WR ÀXVK DQG ULQVH FRQQHFWRU DQG UNIT CLEANING BEFORE FIRST USE AND AFTER USE DAILY, DISASSEMBLE AND CLEAN PUMP AND UNIT. STAINLESS STEEL PARTS CAN CORRODE. IT IS IMPORTANT TO CLEAN, RINSE, SANITIZE, AND DRY THESE PARTS DAILY AND PROPERLY. FAILURE TO COMPLY WITH ANY OF THESE INSTRUCTIONS MAY VOID UNIT WARRANTY. discharge tube thoroughly.
Part # Qty.
ECD 07500 07014 81105 07161 07056 07501 07508 10124 (2) 07518 07505 86337 (4) 07644(2) 07513 81058 (4) 82049
UNIT TROUBLESHOOTING Possible Problems: • Pump dispenses little or no product. • Portion control is not consistent. Possible Solutions: • Clean pump. • Ensure product pouch is not empty. • Ensure product pouch and torsion spring are installed correctly. • Ensure roller is properly installed on lever. • (QVXUH ÀDS LQVLGH SXPS GRPH DQG ÀDS RQ SLQFK valve are properly positioned when assembling pump. • Ensure pump is installed into retaining slot on inside front wall of unit.
