Owner manual

ManualsBrandsServer ManualsKitchenBS/BSA (05020 ) THERMOSTAT

01557-00B-010213

FOR MODELS:

BSA

KIT, REPLACEMENT THERMOSTAT BSA

05020

This kit replaces thermostat 81034

used on Butter Server Automatic (120V)

Series prior to 1981

IMPORTANT INSTRUCTIONS

Kit Parts List

05056 CUT-OUT, THERMAL ASSY, 184C (OR)

05229 KNOB, THERMOSTAT

10001 WRENCH, HEX L-KEY, 1.5MM

11152 TERMINAL, 18-22, QD,.250, FEMALE

11171 NUT, WIRE (QTY 2)

81034 THERMOSTAT, 66C

81283 BRACKET, REPLACEMENT THERMOSTAT

Summary of content (4 pages)

PAGE 1
01557-00B-010213 IMPORTANT INSTRUCTIONS for models: BS BSA KIT, REPLacement THERMOSTAT BSA 05020 This kit replaces thermostat 81034 used on Butter Server Automatic (120V) Series prior to 1981 Kit Parts List 05056 CUT-OUT, THERMAL ASSY, 184C 05229 KNOB, THERMOSTAT (OR) 10001 WRENCH, HEX L-KEY, 1.5MM 11152 TERMINAL, 18-22, QD,.
PAGE 2
Old Thermostat Removal New Thermostat Installation 1 TURN UNIT OFF AND UNPLUG CORD. Allow unit to fully cool before proceeding to next step. 1 2 Remove plastic dome, pump, and stainless steel bowl from unit. install new thermostat onto thermostat bracket With inner vessel in an upside-down position. Align thermostat with angled terminal pointing upward. Secure thermostat with mounting hardware. 3 Remove the two screws at top of operator’s panel.
PAGE 3
Install inner vessel in shroud. Reassemble unit, reversing disassembly procedures above. If unit previously included a small rubber grommet on thermostat shaft hole, remove and discard it. 7 When the temperature reaches the minimum “HEAT up TO” temperature, turn calibration screw two full turns clockwise. 4 INSTALL new thermostat KNOB by aligning knob groove with spline on new thermostat shaft, then push knob onto shaft. (Tighten knob setscrew if used.) 8 Allow appliance to cool to: 135°F (57.
PAGE 4
General Service, Repair, or Returns Before sending any item to Server Products for service, repair, or return, contact Server Products customer service to request a Return Authorization Number. Merchandise must be sent to Server Products with this number. Merchandise being returned for credit must be in new and unused condition and not more than 90 days old and will be subject to a 20% (percent) restocking charge. Electrical parts (thermostats, heating elements etc.) are not returnable.