Manualshelf

Specifications

ManualsBrandsServer Technology ManualsComputer equipmentPT22
71727374757677787980
Operations 71
Installation and Operations Manual
HTTP Administration
NOTE: You will need to restart the PT22 after setting or changing any Telnet/Web configurations.
Enabling and disabling HTTP support:
The Set HTTP command is used to enable or disable HTTP support.
To enable or disable HTTP support:
At the Switched CDU: prompt, type set http, followed by enabled or disabled and press Enter.
Changing the HTTP server port:
With HTTP support enabled, the HTTP server watches and responds to requests on the default HTTP port
number 80. This port number can be changed using the Set HTTP Port command.
To change the HTTP port:
At the Switched CDU: prompt, type set http port, followed by the port number and press Enter.
Example
The following changes the HTTP port number to 2048:
Switched CDU: set HTTP port 2048<Enter>
Sentry Power Manager (SPM) Administration:
The Sentry Power Manager (SPM) is Server Technology’s enterprise management software product for
the data center. The configuration options provided allow you to enable/disable SPM and reset the SPM
password to its default.
NOTE: The SPM options only apply if you are currently using Server Technology’s SPM software. In addition, the SPM
options are only available on the HTTP/SSL web page. There are no equivalent SPM options on the Command Line
Interface (CLI). To configure the SPM options, see the Web interface HTTP/SSL web page.
Telnet Administration
NOTE: You will need to restart the PT22 after setting or changing any Telnet/Web configurations.
Enabling and disabling Telnet support:
The Set Telnet command is used to enable or disable Telnet support.
To enable or disable Telnet support:
At the Switched CDU: prompt, type set telnet, followed by enabled or disabled and press Enter.
Changing the Telnet port:
With Telnet support enabled, the Telnet server watches and responds to requests on the default Telnet port
number 23. This port number can be changed using the Set Telnet Port command.
To change the Telnet socket:
At the Switched CDU: prompt, type set telnet port, followed by the port number and press Enter.
Example
The following changes the Telnet port number to 7001:
Switched CDU: set telnet port 7001<Enter>