Specifications
Mounting
1. Select the appropriate bracket mounting points for
proper mounting depth within the rack.
2. Attach the brac
kets to these mounting points with two
screws for each bracket.
3. Install the enclosure into your rack, using the slots in
each bracket. The slots allow about ¼ inch of
horizontal adaptability to align with the mounting
holes of your rack.
NOTE: A mounting bracket kit for 23” wide racks or cabinets is
available. For more information, contact your Server Technology
sales reepresentative.
Figure 2.1 Mounting
Connecting to the Power Source
The input power cord must first be attached to the unit before connecting the unit to the power source.
Each outlet powers up sequentially, eliminating a potential blown primary fuse or circuit breaker from
excessive in-rush current.
To attach a power cord to the unit:
1. Plug the female end of the power cord firmly into its connector at the base.
2. Use a screwdriver to tighten the two screws on the retention bracket.
To connect to the power source:
Plug the male end of the power cord into the AC power source.
Connecting Devices
1. Keep the on/off switch on the unit in the off position until after the unit is plugged into the outlet.
2. Connect devices to the PT22 outlets.
NOTE: Server Technology recommends even distribution of attached devices across all available outlets to avoid
exceeding the outlet, branch or phase limitations. For more information, see the “Power Ratings” section in Appendix C:
Technical Specifications.
Always disconnect ALL power supply cords before opening to avoid electrical shock.
Afin d’éviter les chocs électriques, débranchez TOUTES les cables électrique avant d’ouvrir.
Immer ALLE Netzleitungen auskuppeln vor den Aufmachen um elektrischen Schlag zu vermeiden.
Connecting the Sensors
The PT22 is equipped with two mini RJ11 temperature/humidity ports for attachment of the
temperature/humidity sensors. Attach the mini RJ11 plug of the sensor(s) to the appropriate ports.
Installation 11
Installation and Operations Manual