Troubleshooting guide

23
Installation and Service Manual
OPERATION
PROGRAMMING MODES
Program
Button
LED
Display
TIMED DISPENSE MODE (Flavor Adder Dispensed)
Once in program mode (2), control board LED displays
(2). Press any touchpad selection area three times in less
than three seconds and selection area LED lights will blink
three times to indicate the touchpad area has been pro-
grammed for timed dispense. Then the first and last
touchpad selection areas will illuminate, which will allow
increasing the timed dispense cycle by .2 seconds each
press of the last illuminated touchpad selection area or
decreasing the timed dispense cycle by .2 seconds each
press of the first illuminated touchpad selection area. To
program another touchpad area for timed dispense press
and release the control board program button to reset the
timed dispense programming mode, first and last touchpad
areas are no longer illuminated. Repeat procedures for
programming timed dispense for other designated
touchpad selection areas. After all designated touchpad
areas have been programmed for timed dispense either
enter another program mode or exit the programming
modes, which will save programming mode changes.
WATER CALIBRATION MODE
Once in program mode (3), control board LED displays
(3). Press any touchpad selection area and the noncar-
bonated water valve will dispense for three seconds in
order to brix the valve. The procedure can be repeated as
many times as necessary in order to brix the noncarbon-
ated water valve. After the water valve has been brixed
either enter another program mode or exit the program-
ming modes, which will save programming mode changes.
SYRUP CALIBRATION MODE
Once in program mode (4), control board LED displays (4).
Press any touchpad selection area and the associated syrup
valve circuit will dispense for three seconds in order to brix
the syrup valve circuit. The procedure can be repeated as
many times as necessary in order to brix all syrup valve
circuits. After all syrup valve circuits have been brixed ei-
ther enter another program mode or exit the programming
modes, which will save programming mode changes.