Users Manual

CONTROLLER FUNCTIONS

Speed – The drone’s responsiveness to the controller’s commands is adjusted into three

different modes by pressing and releasing this button.

• Slow – The drone operates more gently to the commands input at the controller.

This mode is recommended for a beginner drone pilot.

• Medium – The drone operates intuitively to the commands input by the

controller. This mode is recommended as you gain experience as a drone pilot.

• Fast – The drone operates rapidly to any commands input by the controller. This

mode is recommended only after extensive experience as a drone pilot.

Flips – When this button is pressed, the drone enters flip mode. While in flip mode, the

right joystick on the controller can be used to perform a flip by pressing one of the four

directions forward, backward, left, or right.

Ascent/Descent – This is the throttle; it controls the speed of the motors. Pushing up

causes the drone to go straight up; pushing down causes the drone to go straight

down.

Yaw Left/Yaw Right – Rotates the drone around the center of the drone body. It is used

to change the direction the drone is pointing. Pushing left rotates the drone to the left;

pushing right rotates the drone to the right.

Pitch Forward/Pitch Backward – Tilts the drone forward or backward. Pushing up tilts

the drone forward, and it moves forward. Pushing down tilts the drone backward, and

the drone moves backward.

Roll Left/Roll Right – Tilts the drone to the left or right. Pushing right tilts the drone to

the right, and it moves to the right. Pushing left tilts the drone to the left, and the drone

moves to the left.

Takeoff/Land – Pushing and releasing this button will make the drone take off when

not flying and land when flying. Pushing and holding when the drone is in flight will

activate the emergency landing feature, and the drone’s motors will immediately stop

spinning, and the drone will fall directly to the ground.

Power On/Off – Pushing and releasing this button will turn the remote on or off.

Headless/Normal Mode – In normal mode, left and right are always in reference to the

drone’s left and right. In headless mode, left and right are in reference to the controller’s

left and right when facing the drone.

Tune/Normal Mode – In normal mode, the controls operate the motors to cause

movement in the drone. In tune mode, the power sent to each of the motors is adjusted

to balance the flight characteristics of the drone. Each time the drone is restarted, the

previous tuning returns to the default.