Assembly Instructions Lounge Chair So comfortable, you’ ll feel the difference the moment you sit down.
Should you prefer to speak with a customer service representative, you may call toll free : 18553722315.
Limited Warranty Millwork Holdings seating products are warranted against defects in material and workmanship while owned by the “Original Purchaser”. The term “Original Purchaser” is defined as that party or entity which purchases Millwork Holdings furniture from an authorized Millwork Holdings retailer as shown by the original sales receipt. This warranty does not apply to “as is” or previously owned seating products.
Guidelines Thank you for selecting a Serta furniture piece! FAILURE TO FOLLOW THESE WARNINGS WHEN IN USE COULD RESULT IN INJURY Our primary objective is to provide fast, friendly customer service to all of our customers. We are here to help if you have any questions, comments, or are in need of warranty replacement parts. • Do not stand on the item or use as a step ladder.
Pre-Assembly Preparation: Please read through this instruction booklet before beginning assembly of this item. Two adults are recommended for assembly. • Clear out the space for assembly and lay out all parts on Parts List, extra room will allow you to easily determine if all the pieces are present. • Save all packing materials until assembly is complete to avoid accidentally discarding smaller parts or hardware. • Keep small parts and pieces away from children and pets until fully assembled.
Parts & Assembly Chair Quantity: 1 B Base Quantity: 1 E F 1” Screws Quantity: 4 Allen Key Quantity: 1 06 C Gas Lift Quantity: 1 D Seat Plate Quantity: 1 NT FRO A
Assembly: C 1 Step One: Turn the Base (B) over and insert the Gas Lift (C) through the center hole on top of Base (B).
F E Step Two: 3 D T FRON Attach Seat Plate (D) to the bottom of the seat cushion (with the front of the seat plate facing the front of seat cushion). Attach by using 1” Screws (E) for the holes of the Seat Plate (D) with the Allen Key (F). *Note: Align the Seat Plate so the FRONT on the seat plate matches the FRONT label on the bottom of the seat cushion. Tighten the screws completely.
