ASSEMBLY INSTRUCTIONS Arm Chair So Comfortable, the moment you sit down.
Should you prefer to speak with a customer service representative, you may call toll free : 1-855-372-2315.
Guidelines FAILURE TO FOLLOW THESE WARNINGS WHEN IN USE COULD RESULT IN INJURY • Do not stand on the item or use as a step ladder • The piece has been tested and approved for users weighing up to 250 lbs (113kg) per seat. • Do not use this item unless all bolts and screws are firmly secured and fastened. • Check all bolts and screws every 90 days. As necessary tighten if any are loose. • Lift up then move.
Pre-Assembly Preparation: Please read through this instruction booklet before beginning assembly of this item. Two adults are recommended for assembly. • Clear out the space for assembly and lay out all parts on Parts List, extra room will allow you to easily determine if all the pieces are present. • Save all packing materials until assembly is complete to avoid accidentally discarding smaller parts or hardware. • Keep small parts and pieces away from children and pets until fully assembled.
Parts List 2.
Step 1-- Remove all parts from the carton and place them on a protected surface or carpet. Place the Seat Frame (I) upside down and open the bottom flap. Take the Thumb Bolts (A & G), Screws (B), Spring Washers (C), Flat Washers (D), Allen Key (E), Wood Legs (F), Seat Cushion (K) and Seat Cushion Cover (L) out of the seat box.
Step 2 -- 07 Insert Wood Legs (F) into the bottom of the chair as shown and connect with 2.5” Screws (B) with Spring Washers (C) and Flat Washers (D). Do not tighten screws fully until you have completed assembly. Place chair upright on level floor. Make any necessary adjustments to frame to ensure chair sits flat on floor without rocking, then tighten all screws securely with Allen Key (E).
Step 3 -- Attach Arms (H1 & H2) to the seat frame by sliding the receivers into the mechanism posts located on sides of Seat Frame (I). From the front of the chair, press down on both sides of the Arms (H1 & H2) to firmly secure.
Step 4 -- 09 Attach the Back Frame (J) to the Seat Frame (I) by sliding the receivers into the mechanism posts located on the Arms (H1 & H2). From the front of the chair, press down on both sides of the Back Frame (J) with two hands firmly to secure. The Back Frame (J) and Seat Frame (I) will automatically lock into place.
Step 5 -- 1. Insert Thumb Bolts -2.5” (A) x 2 into seat frame holes to sides of Seat Frame (I) and tighten the bolts. 2. Insert Thumb Bolt -1-3/4” (G) into seat frame hole to side of Back Frame (J) and tighten the bolt.
Step 6 -- 11 Secure the bottom flap with the hook and loop tape.
Step 7 -- 1. Open the vacuum packed Seat Cushion (K) by carefully cutting the bag with a pair of scissors. Insert the Seat Cushion (K) into the appropriate Seat Cover (L). Remember to keep the top side of the Seat Cushion (K) with the top side of the Seat Cover (L). Fluff all cushions and pillows to allow them to expand. Lastly, position all cushions and pillows on the chair. Seat and back cushions may take 24-48 hours to fully expand, which will allow wrinkles and indentations caused by packing to fade.
Limited Warranty Millwork Holdings seating products are warranted against defects in material and workmanship while owned by the “Original Purchaser”. The term “Original Purchaser” is defined as that party or entity which purchases Millwork Holdings furniture from an authorized Millwork Holdings retailer as shown by the original sales receipt. This warranty does not apply to “as is” or previously owned seating products.
