SER600019 SRX8 EVO Manual

37
STEp 61 STEp 62
M4x10
M5x4
M3X8
M4x10
M5x4
M3x8
If the engine used is an OS (or OS
based engines like Mx), Alpha and SH,
it might be needed to trim off some
plastic from the center diff cover to give
the carburetor enough clearance over
the brake plates. This could be done
with a hobby knife.
1- Assemble and fully tighten the M4x10 screws.
2- Position the engine in such way on the engine
mount that the gearmesh is correct.
3- Fully tighten M3x14 screws assembled during the
Step 60.