Manualshelf

User's Manual

ManualsBrandsSerome Electronics ManualsComputers & AccessoriesADSL Modem
12345678910
8
%
I
I
n
n
s
s
t
t
a
a
l
l
l
l
i
i
n
n
g
g
S
S
o
o
f
f
t
t
w
w
a
a
r
r
e
e
D
D
r
r
i
i
v
v
e
e
r
r
o
o
n
n
W
W
i
i
n
n
d
d
o
o
w
w
s
s
2
2
0
0
0
0
0
0
This section describes the following procedures on a Windows 2000 system to use the
M-CNX-DSL-PCI2 ADSL modem.
' Installing the software driver
' Setting the VPI, VCI
' WAN driver : Creating a new connection profile / LAN driver : Setting the TCP/IP
Installing Software Driver
M-CNX-DSL-PCI2 ADSL modem software driver is composed of the following three
device drivers.
' Basic System Device
' ATM Network Controller
' DSL Network Device
Installation procedures of each device driver are same. So, during installing the
M-CNX-DSL-PCI2 ADSL modem driver, the step 3 ~ 8 in the following procedures are
repeated three times.
1. Power on your computer.
2. After a while, Windows 2000 detects the M-CNX-DSL-PCI2 ADSL modem and the
<Found New Hardware Wizard> displays a message a system device was detected.
Click [Next>] to go to the next wizard panel.
3. Two choices appear. Choose ‘Search to for a suitable driver for my device
(recommended)’ and click [Next>] to go to the next wizard panel.
4. The wizard prompts you to specify a location to search for the driver you are
installing. Click ‘Specify a location’ and click [Next>] button. An then, insert the
installation driver CD into the CD-ROM drive.
5. Click [Browse] and according to the software to install, select the following
directory path and click [OK].
Software Directory
WAN
<CD-ROM Drive Letter>:\WAN
LAN
<CD-ROM Drive Letter>:\LAN
6. If the path is correct, the wizard shows a verification panel(Driver Files Search
Results) and displays the choice you made. Click [Next>] to go to the next panel.
7. The system finds the driver and begins to automatically copy the driver files from
the CD. When the copy is complete, click [Finish] button.
8. After completing the driver installation wizard, set the VPI and VCI value of the
channel referring to the next section. And then, according to the installed driver,
create the new connection profile(refer to the section, ‘Creating a New Connection
Profile : In Case of the WAN Driver’) or set the TCP/IP (refer to the section ‘Setting
the TCP/IP : In Case of the LAN Driver).