Manualshelf

User's Manual

ManualsBrandsSerome Electronics ManualsComputers & AccessoriesADSL Modem
12345678910
5
$
I
I
n
n
s
s
t
t
a
a
l
l
l
l
i
i
n
n
g
g
S
S
o
o
f
f
t
t
w
w
a
a
r
r
e
e
D
D
r
r
i
i
v
v
e
e
r
r
o
o
n
n
W
W
i
i
n
n
d
d
o
o
w
w
s
s
9
9
8
8
This section describes the following procedures on a Windows 98 or Windows 98
second edition system to use the M-CNX-DSL-PCI2 ADSL modem.
' Installing the software driver
' Setting the VPI, VCI
' WAN driver : Creating a new connection profile / LAN driver : Setting the TCP/IP
Installing Software Driver
M-CNX-DSL-PCI2 ADSL modem software driver is composed of the following three
device drivers.
' Basic System Device
' ATM Network Controller
' DSL Network Device
Installation procedures of each device driver are same. So, during installing the
M-CNX-DSL-PCI2 ADSL modem driver, the step 3 ~ 8 in the following procedures are
repeated three times.
1. Power on your computer.
2. After a while, Windows 98 detects the M-CNX-DSL-PCI2 ADSL modem and the
wizard displays a message a system device was detected. Click [Next>] to go to
the next wizard panel.
3. Two choices appear. Choose Search to find the best driver for you device and
click [Next>] to go to the next wizard panel.
4. The wizard prompts you to specify a location to search for the driver you are
installing. Click Specify a location and click [Browse] button. An then, insert the
installation driver CD into the CD-ROM drive.
5. According to the software to install, select the following directory path and click [OK].
Software Directory
WAN
<CD-ROM Drive Letter>:\WAN
LAN
<CD-ROM Drive Letter>:\LAN
6. If the path is correct, the wizard shows a verification panel and displays the choice
you made. Click [Next>] to go to the next panel.
7. The system finds the driver and begins to automatically copy the driver files from
the CD. When the copy is complete, click [Finish] button.
8. After completing the driver installation wizard, the system prompts you to reboot.
Click [YES] to reboot the system.
9. After rebooting the system, set the VPI and VCI value of the channel referring to the
next section. And then, according to the installed driver, create the new connection
profile(refer to the section, ‘Creating a New Connection Profile : In Case of the WAN
Driver’) or set the TCP/IP (refer to the section ‘Setting the TCP/IP : In Case of the
LAN Driver).