User guide

Phy Mode: Select the supporting Physical mode (CCK, OFDM, or HTMIX) . The same physical
mode must exist for all of the connecting equipment.
Encrypt Type: Select NONE (no encryption type). There are 3 types: WEP, TKIP (Temporal Key
Integrity Protocol) and AES (Advanced Encryption Standard) . You can set a maximum of four
different types and can use these types to connect to four different clients.
Note: The same encryption type must exist for all of the equipment to the connection to be
established.
Encrypt Key: Input a new key here after choosing the Encrypt Type.
2.Bridge Mode
The Bridge mode requires the BSS ID of the other client to be filled in. The AP SSID of this router
will be shielded so that the wireless client will not be able to determine this router. The wired client
can use a WAN port to access the Internet.
Phy Mode: Select the supporting physical mode (CCK, OFDM, or HTMIX) . The same physical
mode is required for all connecting equipment .
Encryp Type: Select NONE (no encryption type) . There are 3 types: WEP, TKIP (Temporal Key
Integrity Protocol ), and AES (Advanced Encryption Standard). You can set a maximum of four
different types and can use these types to connect to four different clients.
Note: The same Encrypt Type must exist for all connecting equipment in order to establish a
connection .
AP MAC address: Fill in the BSS ID of the WDS connecting equipment. You can fill in four different
BSS IDs in order to enable one-to-many connections.
3.Repeater Mode
You have to input the BSSID of the connected equipment. Either a wireless client or a wired client
(not a bridge ) can connect to the network in the WDS mode.