Operation Manual

56 Working with Pages
Ruler units
To select the basic measurement unit used by the rulers:
• Right-click the Ruler Intersection and set the measurement unit
from the flyout.
In Paper Publishing mode, the default unit is inches (US) or centimetres
(international); in Web Publishing mode, only pixels can be used.
Adjusting rulers
By default, the horizontal ruler lies along the top of the PagePlus window and
the vertical ruler along the left edge. The default ruler intersection is the top-
left corner of the pasteboard area. The default zero point (marked as 0 on each
ruler) is the top-left corner of the page area. (Even if you have set up bleed area
guides and the screen shows an oversize page, the zero point stays in the same
place, i.e. the top-left corner of the trimmed page.)
(A) Ruler intersection; (B) drag tab marker to set new zero point.
To define a new zero point:
• Drag the tab marker on the ruler intersection to a new zero point on
the page or pasteboard. (Be sure to click only the triangular marker!)