Owner Manual

5) Installing Shower Door:
*Note: For DSE-7, 8 and CSE 9 & 10 Models – Door swing must be in the same direction for
Handle to Align Properly. Make sure the unit is secured to the surface and level so the
door sits plumb. Determine your door swing prior to moving on. All screws for the door are
included in the door hardware box.
a. Follow steps from 2a & 2b to ensure the header bracket is
installed PRIOR to door installation.
b. Using provided jig, set on outside of post and draw three
separate marks going down the side of the post where the
door hinge will sit. Hinge pin must be on outside of post
when door is closed. (See PIC 5b)
*Important: This will ensure the hinge is secured straight
on the post.*
c. Install the door hanger on the top corner (hinge side) of the
front of the door.(See PIC 5c-1) Hang the door so that the
door hanger is on the top of post that the hinge will be on so that the door will be in the
fully open position. (See PIC 5c-2) Door should align with the lines that were drawn in
step 5b. Using the self-tapping stainless steel screws, attach the hinge to the post
(inside) into the pre-drilled holes. (See PIC 5c-3) * Must start with the bottom screw
and work your way up to the top screw.*
*The bottom of the door must align with the bottom of adjacent wall panels.
PIC 5c-2
PIC 5c-3
PIC 5-b
PIC 5c-1