Owner Manual

Contact us at 888-392-9625 or email us at [e-mail] with any questions during the
installation process. Our service team is available 24/7.
Floor Model Options
Tools Required:
Tape Measure, Screw Gun, Level, Pencil, 1/2” Socket Wrench and Silicone.
*All hardware for shower parts are included in each part box. #2 Square tip bit is included in
door hardware box.*
You will need to purchase the necessary screws/bolts to mount unit to the ground. If placing
shower on pavers, cement or blacktop; you will need 2” X ¼” Simpson Strong Tie “Titan”
(Approved for 115 MPH Wind zones) or equivalent masonry anchor, washers and a ¼” masonry
drill bit (4 screws for a double unit and 4 screws for a single unit).
If placing your shower on gravel, grass or dirt, we recommend that you use a 6 x 6 pressure
treated wooden base or stack (3) 2 x 6 pressure treated boards.
*Set chuck on drill to #7 when installing screws. Higher speeds will break screw.
Single Models Size: 46”d x 46”w x 88”h, 36”d x 36”w x 88”h - 89 1/2”h with roof
Model SSE-1
Model SSE-2
Double Models Size: 46”d x 88”w x 88”h, 36”d x 68”w x 88”h – 89 ½”h with roof
Model DSE-1
Model DSE-2
Model DSE-3
Model DSE-5
Model DSE-6
Model DSE-7
Model DSE-4
Model DSE-8