User`s manual

50
5) SMTP
The NVR can be configured to send event and error email messages via SMTP (Simple Mail Transfer
Protocol).
• SMTP(E-Mail) Setting
Select “Enable” to activate the SMTP operation.
-. Mail Server / Port:
Enter the host names (or IP addresses) and port numbers for your mail server in the fields
provided, to enable the sending of notifications and image email messages from the camera to
predefined addresses via SMTP.
-. Sender:
Enter the email address to be used as the sender for all messages sent by the Network
Transmitter.
-. Interval:
Represent the frequency of the email notification when an event occurs.
-. Aggregate events:
Shows the maximum number of emails sent within each interval.
If your mail server requires authentication, check the box for Use authentication to log in to this
server and enter the necessary information.
-. User Name/Password:
Enter the User Name and Password as provided by your network administrator or ISP (Internet
Service Provider).
To ensure that the login procedure is performed as securely as possible when using SMTP
authentication, you must define the weakest authentication method allowed.