Operating instructions

How to Install the Access Panel Grill
1. Lay the Finishing Surround on its face and position the Access Panel Grill in the fashion
shown in Figure 14. Ensure that a soft cloth is placed underneath the Finishing Surround and
the Access Panel Grill to avoid scratching.
2. Ensure that the magnets (2pcs) are placed on the appropriate tabs as shown in Figure 14.
3. Using the thumb screws, washers, and locking nuts provided fasten the Access Panel Grill to
the Finishing Surround frame. Observe the locations of the screw, washer, and nut. Torque the
nut appropriately to the desired tightness.
4. To remove the Access Panel Grill simply reverse these steps.
Figure 14 - Lower Access Panel installation and removal guide.
NOTE: By bending the Magnet Tabs back or forth, the alignment of the Lower Access Panel can
be adjusted. However, excessive bending may result in the Magnet Tabs breaking.
17