User Manual

STEP 3. FRAME COVER ASSEMBLY

•

Place the Padding Cover (#5) over the frame and springs.

•

Tie the elastic strap underneath the cover to Frame Tube (#1) as shown.

•

To make sure there’s no gap left between the Jumping Mat (#4) and the Padding Cover (#5) to prevent

foot getting caught during use, “sew” these two pieces together with Rope (#6).

•

Tie one end of the rope to one of the triangle rings of the jumping mat, and thread the other end

through the mesh skirt of the padding, then to the next triangle ring, the mesh skirt… until you reach

the end of the rope. Tie it to the last eyelet in reach.

•

Continue the same step with the 2 Ropes (#6) left by xing it to the last triangle ring where the previous

Rope (#6) ends. Until all the eyelets are rmly connected with the mesh.