SLTM20 Infrared Digital Thermometer Touchless Thermometer for Adults and Kids with LCD Display, Fever Alarm, and Memory Recall
Please read this manual completely before operation INDEX 1. Introduction 3 2. Meter Description 3 3. Display Layout 5 4. Battery Installation 5 and Replacement 5. Operation 6 6. Maintenance, Storage and 8 Calibration 7. Troubleshooting 10 8. Name and Content of Toxic 10 or Harmful Substances 9. Device and Label symbols 11 10. Features and Technical Specs 12 11. Limited Warranty 13 2 www.SereneLifeHome.
1. Introduction Please read this instruction completely and carefully to ensure safe use, accurate results and long operation life. This device offers fast response and high accuracy to read the body temperature by scanning forehead in a non-contact manner. This product is applicable for use in households. It is not intended to diagnose or treat any health problem or disease and should not be used as a substitute for the consultation and advice of a physician or other medical professional.
1. IR sensor: Used to measure temperature on the forehead 2. Display Screen 3. Tone button: Turn ON/OFF the buzzer. A tone icon is present in the display screen when it’s on. 4. °C/°F switch button: Press and release to switch between Fahrenheit and Celsius. The default setting is Celsius and a “°C” icon appears in the display screen. A “°F” icon was shown while Fahrenheit is used. 5. Mode switch button: Press and release to switch between “Body temperature” mode and ”Surface temperature” mode.
3. Display Layout 1 2 4 5 8 3 6 7 1. Body measurement mode 2. Tone icon 3. Backlight on icon 4. Data hold icon 5. Temperature readout 6. Temperature unit symbol 7. Low battery icon 8. Data records 4. Battery installation and replacement 4.1 Battery installation (Complimentary with 2 DC 1.5V batteries) Open the battery cover and put the two AAA batteries into battery compartment in correct polarities. Push the battery cover back to close. www.SereneLifeHome.
4.2 Battery replacement When the low battery icon ” ” appear on the display, replace the battery as soon as possible. Replacing step is similar to the installation. The batteries used in the infrared Thermometer are two AAA batteries. Either rechargeable or nonrechargeable batteries can be used in the thermometer. Dispose of the expired batteries in accordance with local environmental policies to avoid the irreversible pollution. 5. Operation 5.
After pulling and releasing the trigger, the temperature reading will be displayed with a beep when the tone model is on. If the temperature measurement is below 32°C or 89.6°F, a “Lo” symbol will appear. If the reading is above 42.9°C or 109.22°F, a “Hi” symbol will be displayed. Meanwhile, the buzzer will send out a Di-Di-Di alarm when the tone model is on. The screen will change from green to red at the same time, if the backlight is on. One more test would be applicable in both conditions.
It should only be used under the supervision of an adult. It is prohibited to immerse the thermometer in any liquid or to be exposed to excessive or low temperatures for long periods (see the suggestive operating environment in the manual). It is prohibited use in strong electromagnetic interference environment, such as microwave ovens, mobile phones, induction cookers, etc. 5.2 Memory model The model was only valid in body temperature model.
Maintenance The body of the thermometer can be cleaned with a soft, dry cloth. Do not use water to wash the thermometer. Do not use cleaning agents other than alcohol, such as abrasives, thinners or gasoline. The lens should be cleaned before and after each use. An alcohol swab, or a soft cotton cloth moistened with 70% isopropyl alcohol, could be used to gently clean the lens. Never use a paper towel to clean the probe tip, as it may scratch the lens.
Calibration The thermometer is factory-calibrated and the accuracy has been strictly tested. To ensure the precision and accuracy, 1 year periodic calibration is recommended. Do not try to modify or reassemble the device by yourself. If any problems, contact with the dealers or the manufacturers. 7. Troubleshooting Error Symbol Hi Lo Problem or Cause Solution Temperature Reposition the measurement thermometer is above 42.9°C and try again. or 109.
8.
10.
11. Limited Warranty The warrantor guarantees that its Infrared Thermometer will be free from manufacturing defects for a period of three years from the date of purchase. This warranty does not cover batteries or other power sources that may be provided with or used with the device. This warranty is voided if the Infrared Thermometer is misused or abused in any manner.
Questions? Issues? We are here to help! Phone: (1) 718-535-1800 Email: support@pyleusa.
