SLSPSKT205 2 Pcs.
Carefully read through these installation instructions before installing, operating or servicing PV system. Failure to follow these instructions may result in bodily injury or damage to property. Keep these instructions! Working on a PV system (installation, setup, maintenance, repairs) must be carried out by qualified and authorized persons. Electrical Characteristics The tolerance of Electrical Characteristics is ±3% under standard conditions (irradiance of 1000mW/cm2, AM 1.
When breaking a connected string of modules (e.g.
• Environmental Conditions. The module is intended for use in temperate climatic conditions. The module is “non-explosion-protected equipment”. Hence it must not be installed in the proximity of highly inflammable gases and vapors (e.g. filling stations, gas containers, paint equipment). The module must not be installed near to naked flames or flammable materials. Do not expose modules to concentrated light sources. It must not be immersed in water or constantly exposed to water (e.g. from fountains).
• Optimum Orientation and Tilt To achieve the maximum annual yield figure out what the optimum orientation and tilt of the PV modules is. If sunlight shines vertical onto the PV modules you have the best conditions to generate maximum power. • Avoid Overshadowing Even the slightest partial shading (e.g. from dirt deposits) will cause a reduction in yield.
MOUNTING Installation of Frame and Module The depth is no less than 3mm when installing the module into the frame. 1 1. Module 2. Silica 3 3. Aluminum Frame 2 Connection between frames The depth is no less than 3mm when installing the module into the frame. Aluminum Frame Installation Requirements Each module must be securely fastened at a minimum of 4 points. The frame has been stress tested for mounting on the long sides. The module must not be secured by its short sides. 6 www.SereneLifeHome.
Example for mounting the PV modules to the substructure: 1 2 4 5 3 1 2 3 Example A: Bolting 1. Stainless steel M6 nut 2. Stainless steel spring washer 3. Stainless steel M6 t-head bolt Example B: Clamping on 4. Aluminum clamping plate 5. EPDM washer 2mm We recommend using a torque wrench for installation. In example B, the tightening torque (using stainless steel M6 bolts) should be around 15-20Nm.
Keep connectors dry and clean and ensure that caps are tightly sealed before connecting modules. Faulty connections can result in electrical shock so make sure to fasten all connections securely. Our modules can be installed in landscape or portrait orientation. Make sure that the proper distance between the panels and the surface to allow for air circulation. Portrait Orientation Landscape Orientation Series Connections are just plug and play with the male and female MC4 connectors.
FOR THE WIRING, PAY ATTENTION TO: • Correct wiring scheme When designing the system, avoid forming loops (to minimize risk in the event of an indirect lighting strike). Check that wiring is correct before starting up the generator. If the measured open circuit voltage (Voc) and short-circuit current (Isc) differ from the specifications, then there is a wiring fault. • Use of suitable materials Use cable extensions and plugs that are designed for outdoor applications.
MAINTENANCE AND CLEANING Do not change the PV components optionally (diode, junction box, plug connectors). Given a sufficient tilt (at least 15°), it is not generally necessary to clean the modules (rainfall will have a self-cleaning effect). In case of heavy soiling (which will result in output reductions), we recommend cleaning the modules using plenty of water (from a hose) without cleaning agents and using a gentle cleaning implement (a sponge).
Features: • Includes 30A PWM Controller with LCD Screen • Portable and Easy Set-Up • Sleek Design for Aesthetic Quality • Grade A Mono Solar Cells • Higher Module Conversion Efficiency • Each Panel Produces 300-600Wh a day • Generates 5.
Questions? Issues? We are here to help! Phone: (1) 718-535-1800 Email: support@pyleusa.
