User Manual

www.SereneLifeHome.com 9
• Press the wind speed key to select the appropriate wind speed, which can cycle
to select low, medium and high wind.
• After the cool mode is selected, press and hold the up key and timing key on
the operation panel at the same time to enter the sleep mode, and the wind
speed of the upper and lower fans is forced to be set to low wind.
To cancel sleep, press the key combination again or change the mode to cancel
the sleep function.
2. Dry mode
• Press the mode key to select the dry mode in the start up or timing start up
state. At this time, the corresponding indicator light is on.
• Temperature and wind speed are not adjustable.
3. Fan mode
• Press the mode key to select the fan mode in the start up or timing start up
state. At this time, the corresponding indicator light is on.
• Press the wind speed key to select the appropriate wind speed, which can cycle
to select low, medium and high wind.
• The temperature is not adjustable.
Note:
1. When the full water indication is displayed, the machine will stop working.
You should drain the water in time, and then the machine can start up and run
normally.
2. In dry and fan mode, you may not use the exhaust duct.
3. If your room is facing the sun, please close the curtains.
Installation
1. Select installation location
When the machine is installed in a at and
dry place, 50 cm space must be left around
the machine to make the air ow smoothly.
As shown in Figure 5, the best installation
distance is 50 cm from the back of the machine
body to the wall and 90 cm from the air outlet
to the ground.
Figure 5
50cm
90cm
9
10