SLPAC14 Portable Air Conditioner Compact Home A/C Cooling Unit with Built-in Dehumidifier & Fan Modes, Includes Window Mount Kit (14,000 BTU)
Read all instructions carefully before setting up and operating the unit. Please keep this instruction manual for future reference. This manual is designed to provide you with important information needed to setup, operate, maintain and troubleshoot your portable air conditioner. Failure to follow these instructions may damage and/or impair operation and void the warranty.
Attention Points For the health of you and your family, please read the following carefully before using the unit Requirement: • Please place the unit in a flat and dry place. Keep the air conditioner 50cm. away from the surrounding objects. • The power supply of the air conditioner shall comply with the safety specifications for the use of the ground, and ensure reliable grounding. • After the air conditioner is installed, make sure that the plug is intact and firmly inserted into the socket.
Prohibition: • This air conditioner is for household use only and should not be used in other occasions. • Do not install the unit in the laundry room or other places with water and humidity. • Do not turn on or off the unit by plugging in or pulling out the plug. • Do not put things on this unit. • Do not put anything into the air inlet and outlet. • Do not use insecticide sprays or other combustible substances near the air conditioner. • Do not splash oil or water into the air conditioner.
Parts Name: 1. Control Panel 2. Wind Guide Bar 3. Exhaust Hose Assembly 4. Casters 5. Handle 6. Air Intake Grille 1 7. Power Cord 8. Filter 9. Air Outlet 10. Power Cord Buckle 11. Drainage outlet 2 5 8 9 10 6 3 7 Figure 1 4 Figure 2 11 Control Panel Note: If the machine is shut down in the cooling or heating operation state, it needs to wait for three minutes before it can be turned on automatically. HIGH MID °C Hr LOW COOL FAN DRY °F TIMER SPEED MODE POWER Figure 3 www.SereneLifeHome.
Panel Description 1. Button and Display POWER: Press this key to turn the unit on or off. MODE: Press this key to select cool mode, fan mode or dry mode when starting or timing starting. When the mode is selected, the corresponding ndicator lights up. UP/DOWN: Press the key at cool mode to increase/reduce the setting temperature; press it at timing mode to adjust time; press Up and Down keys simultaneously to switch Fahrenheit and Centigrade degree temperature.
The key operation instructions of this high quality remote control are as follows: 1. POWER: Press the key to turn ON/OFF the unit. 2. MODE: Press the key to choose cool, fan and dry mode. 3. UP: Press this key to increase the temperature and timing settings. 4. DOWN: Press this key to decrease the temperature and timing settings. 5. FAN: Press this key to cycle select the output wind speed between the high, middle and low wind speeds. 6. TIMER: Press this key to set the timing. 7.
Operation Method Time Setting 1. Setting of timing shutdown In the running state of the machine, press the timing key, the timing LED will be on, and the 88 display will flash "0" for 5 times. At this time, press the up and down keys to adjust the time from 1 hour to 24 hours, and change it for 1 hour for each up or down adjustment. When the set time is up, the machine will shut down automatically. 2.
• Press the wind speed key to select the appropriate wind speed, which can cycle to select low, medium and high wind. • After the cool mode is selected, press and hold the up key and timing key on the operation panel at the same time to enter the sleep mode, and the wind speed of the upper and lower fans is forced to be set to low wind. To cancel sleep, press the key combination again or change the mode to cancel the sleep function. 2.
2. Assembly method of exhaust pipe • Connect the exhaust pipe assembly with the round joint (as shown in Fig. 6). • Fix the circular end of the connected exhaust pipe assembly at the air outlet of the machine according to the direction shown in Fig. 7. • Connect one end of the oblate joint of the connected exhaust pipe assembly with the window sealing plate. • Install the seal to the nearest window. Make sure there is no obstacle within 50 cm outside the window to ensure smooth exhaust.
vertical window horizontal window Figure 8 Figure 9 4. Install the fixed window sealing plate on the window; 5. Clip the exhaust pipe assembly (flat end of exhaust nozzle) into the window sealing plate assembly, and use the Screw fixation. 4.Installation diagram 9 Figure 10 Figure 11 10 www.SereneLifeHome.
Drainage Operation • When the refrigeration mode or drying mode is operated in wet weather, there is a lot of condensed water. When the water level of the water receiving tray reaches a certain position, the water full alarm will be issued to stop the compressor. The indicator of full water on the display will be on, and the alarm will sound at the same time until the water level of the water receiving tray is lower than the alarm level or the water of the water receiving tray has been drained manually.
2. Cleaning of filter screen • If the filter is blocked by dust, it will lead to poor air circulation and reduce the efficiency of air conditioning. • In the case of long-term use of air conditioning, it is recommended to clean the filter every two weeks. 1. Pull out the filter in the direction shown in Figure 13. 2. Put the filter into the warm water (about 40°C/104°F) with neutral detergent to clean it, and then dry it in the shade.
TROUBLESHOOTING Before contacting a professional electrician, please check as follows: TROUBLE CAUSE The air conditioner doesn’t work Is the power off? Is the plug not inserted? Is the fuse blown or closed? Is the time setting appropriate? Is there a full water warning? Is the air inlet and outlet blocked? Is there any other heating source in the room? The air conditioner is Is the filter too dirty? Is the temperature setting not cooling appropriate? Is the fan speed set to the lowest gear? The air cond
Intelligent detection function Error-detecting code Multi-functional defection E1 Coil sensor sensing abnormal E2 Abnormal perception of room temperature sensor E4 Anti-freezing protection FL The machine is in full water alarm state Do not place the waste separately for other special purposes 9 10 www.SereneLifeHome.
FEATURES: • Removes up to 50 pints/24 hours with Continuous Drain Option for Long Unattended Operation • Automatic Self-evaporation Technology • Metal Control Box to Prevent from Fire and Exploding • Rotary Compressor • Universal Castors for Moving Freely • Wifi function • Lightweight & Portable A/C Unit • Compact Freestanding Room Air Conditioner • (3) Operation Modes: AC Cooling / Dehumidifier / Fan • Hassle-Free, Quick Setup Cooling • Simple Electric Plug-in Operation • Convenient Wide-Area Climate Con
TECHNICAL SPECS: • Power Supply: 115V/60Hz • Rated Power: 1220W • Refrigerant Type: R32 • Cooling capacity (ASHRAE): 14,000 Btu/h • Cooling capacity (DOE): 10,000 Btu/h • Coverage Area: Cools Rooms up to 500 Square Feet • Air Flow: 400 Cubic Meters / Hour • Operating Modes: Cool / Fan / Dry (Dehumidifier) • Moisture Removal / Dehumidifier: 1.
Questions? Issues? We are here to help! Phone: (1) 718-535-1800 Email: support@pyleusa.