User Manual
S5
www.S ereneLifeHome.com
6
STEP 3
Turn the Computer up or down to align the bolt hole on the Handlebar. Lock the Computer in
place by tightening two Locking Knobs (S5).
IMPORTANT: While sliding the Handlebar onto the both Left/Right Support Tubes, make sure the
cables are installed inside the Right Support Tube and pay attention not to pinch the cables.
STEP 4
Install both Left/Right Handlebar Support Tube Covers (S7) onto the both Handlebar Support Tubes .
STEP 5
Before beginning a workout session ensure that the Safety Tether Key is properly placed onto the Computer
Console and the Safety Clip is securely attached to an article of your clothing. If you fall the clip will pull out
the SAFETY KEY from the Computer Console and the running belt will stop immediately for emergency
stop, helping to prevent injury. Replaced the Safety Tether Key onto the Computer Console. Press the
START button to begin exercise again.
S7
S7
S6