Kids Toy Electric Ride On Bumper Car Vehicle with Remote Control, LED Lights and 360 Degree Spin, 2 Driving Modes
The owner’s manual contains important safety information as well as assembly, use and maintenance instructions. The Ride On Bumper Car must be assembled by an adult who has read and understands the instructions in this manual. • Keep the package away from children and dispose of properly before use. • Keep this manual for future reference. • Styles and colo(u)rs may vary. • Made in China. About Your New Ride-On On the purchase of your new Ride On Bumper Car.
SAFETY The following safety hazards may result in serious injury or death: • Never leave child unattended. Direct adult supervision is required. Always keep child in view when child is in vehicle. • To reduce the risk of injury, adult supervision is required. Never use in roadways, near motor vehicles, on or near steep inclines or steps, swimming pools or other bodies of water, always wear shoes, and never allow more than 1 rider.
Parts List PART NO. Q’ty (pcs) PART NAME 1 2 3 4 Vehicle body 1 Back rest 1 Charger 1 Remote controller 1 REMARKS For R/C type only 3 2 4 4 www.SereneLifeHome.
Assembly 1 1. Fit the back rest into the groove on the body, push until you hear it “click” into place. 2. Loosen two screws on the top of the seat with a screwdriver and remove the seat. 3. Plug the connector on the vehicle body into the connector from the battery. 4. Replace the seat. 2 3 www.SereneLifeHome.
Use Your New Ride On Standard 3 V+ V- 4 ►II ►►I V+ V- 2 Option II Option I 5 2 ♫ 6 1 7 1. Power button: Turn the product on and off. 2. Left and Right joysticks: Control the product to move forward, backward, turn left (circle) and right (circle). Standard Edition 3. Lights button: Turn the lights on and off. Press and hold to increase volume. 4. Music button: Press for music/sound playing. Press and hold to decrease volume. Option I Edition (if equipped) 5.
Charging WARNING! • ONLY an adult is allowed charge and recharge the battery! • This product with Charging Protection: When charging, all functions will be cut off. • The POWER SWITCH must be turned in OFF position when charging. • Before the first use, you should charge the battery for 4-6 hours. Do not recharge the battery for more than 10 hours to avoid overheating the charger. • When the vehicle begins to run slowly, recharge the battery.
Troubleshooting Guide Vehicle does not run Vehicle does not run very long Battery low on power Recharge battery. Thermal fuse has tripped Reset fuse, see Battery connector or wires are loose Check that the battery connectors are firmly plugged into each other. If wires are loose around the motor . contact your distributor please. Battery is dead Replace battery, contact your distributor please. Electrical system is damaged Contact your distributor please.
Maintaining • It is parent's responsibility to check main parts of the toy before using. Must regularly examine for potential hazard, such as the battery, charge, cable or cord, plug, screws are fastening enclosure of other parts and that in the event of such damage, the toy must not be used until that damage had been properly removed. • Park the vehicle indoors or cover it with a tarp to protect it from wet weather. • Recharge the battery after each use. Only an adult can handle the battery.
Use the Remote Controller WARNING: ADULT OPERATING REQUIRED! Brake button Forward button Right turning button Reverse button Left turning button Connect button Indicators The remote control has precedence over foot pedal operation. (The foot pedal won’t work while you operate the Remote Controller) 1. Connect button (build connection): Lift the battery compartment door on the back of the controller and insert two AAA (LR03) batteries. NOTE: Batteries not included.
Features: • 360° Spinning Bumper Car • High-Quality and Adjustable Safety Belt • Light Button, Control Panel and Soft Bumper • Anti-Flat Tires • Colorful Flashing Lights • Built-in Rechargeable Battery • Durable Wheels for more Flexible Steering • Easy to Install and Use • No Assembly Needed What's in the Box: • Ride-on Bumper Car • Remote Control • Charger (12V500mA) Technical Specs: • Construction Material: PP • Motor: 12V/30W • Speed: 1.
Questions? Comments? We are here to help! Phone: (1) 718-535-1800 Email: support@pyleusa.
