User Manual

ww w.SereneLifehome.com

HEATER

● This appliance is equipped with a built-in heater which works when the

appliance is switched on.

● The heater is not designed for heating up a cold bath but maintaining the

water temperature better with warm air created by the main unit.

● It is suggested to run the appliance 3 - 5 minutes as warm up before you

enter the bath tub. This avoids a cooling effect on the skin due to the

bubbles generated in the first few minutes might be relatively cold.

ALCI Safety Device

This appliance is provided with an appliance leakage circuit interrupter

(ALCI) safety device. This device is designed to make the unit inoperable

under some abnormal conditions. The ALCI safety device is equipped with a

test button in order to check its operation. This unit should be tested before

using to make sure the safety device is operational.

ALCI Testing

It is recommended to test the ALCI before using the appliance each time.

After plugging it in:

1. Press the reset button on the ALCI device.

2. Press the test button. The reset button should pop out and the appliance

will stop the operation. This verifies that the safety device is operating

properly.

3. Press the reset button to reactivate your ALCI safety device.

4. The bubble bath mat now is ready for use.

Note: If the reset button pops out during use, press the reset button. If the

reset button cannot be pressed down, stop using the appliance and

return it to the distributor or the designated service center.

Technical Data:

Voltage: 120V ~ 60Hz

Watts: 470W

Remote Control: 3V CR2032 Lithium Battery