Specifications

Dialing from a One-Touch Memory
1. While off-line, press any one-touch memory key to hear
audio confirmation (assume talking feature is on).
2. Press to go on-line and dial.
3. Press to end the call.
Change Handset Ringer Tone and Volume
Note: Base ringer tone is fixed. Base ringer volume is controlled
by a slide switch located on the side of the base.
Ringer tone or melody setting
1. While of f -line, press key plays the current ringer melody.
2. Press the key on the side of handset to change the
ringer melody (ten melodies total).
3. Press and hold key for 5 second to save the latest
Ringer volume setting
1. While off-line, press key plays the current ringer melody.
2. Press the
key on the side of handset to change the
ringer loudness (five loudness level total).
3. Press and hold fo 5 second to save the latest loudness
Register a New Handset to the Base
Note: Handset and ba se are pre-registered with each other in
the factory . They are ready to use out of the box. You only need
step if you bought an extra handset to do this for the system.
1. Press key on the base for about 5 seconds while
the ringer. setting for
of five handsets is allowed A maximum
off -line, the Ring-Flasher light starts flashing after a loud
beep. This indicates the base is ready for handset
registration. (Please complete the following steps in less
PAGE
than 120 seconds).
1. While of f -line, press and hold key for 3~5 seconds
the dialing mode toggles from tone and pulse (or vice-versa).
2. The dialing m ode is announced in voice if the Talking feature
Confirm the correct di aling mode by calling a phone number.
Battery Low Warning Tone
While talking, there will be a periodic short beep sound if the
battery is running low. Please recharge handset as soon as
2. While of f -line, press and hold the key on the side of the
handset for about 5 seconds. It beep s once and starts
searching for the base.
3. W a it about 5 to 30 seconds for registration to take place.
A long "du di du"sound indicates a successful registration.
De-Register All Handsets
This step is necessary only if there are too many handsets
registered to the base and there is difficulty in registering a new
1. Press key of base for 5 seconds and the base ringer
flasher indicator starts flashing.
2. Press the key of base seven more times at a normal
pace; the ringer flasher indicator should flash at a faster speed
than before indicating de-register process is in progress.
3. De-register is complete w hen the indicator light goes out.
4. All previously registered handse t
s
are now de-registered.
5. Y o u must register the handsets you want again.
Dialing Mode Setting
Both CL-65 and 30 are factory preset for tone dialing
PAGE
handset.
PAGE
is on.
possible.
9 10
melody for the ringer.