User's Manual

Rear - xCAM

Figure 2: Rear Panel

RJ-45 Jack

This RJ-45 connector is used for power connection when the camera

is under wireless mode. A customized PoE (Power over Ethernet)

splitter, as a Y-cable, is provided to allow connection to PC for

setup and pairing.

Reset Button

This button has two (2) functions:

• Reboot. When pressed and released, the xCAM will reboot

(restart).

• Clear All Data. This button can also be used to clear ALL data

and restore ALL settings to the factory default values.

To Clear All Data and restore the factory default values:

1. Power On.

2. Keep holding the Reset Button down for 8 seconds.

3. Release the Reset Button. The xCAM is now using the factory

default values.

Microphone

The built-in microphone is located on the rear of the device.