User's Manual

6. Install the xCAM.

Figure 3: Camera Installation

a. Connect the provided Y-cable to the XW3 and the Home Gateway.

b. Use the xCAM pigtail Ethernet RJ-45 to connect the LAN port of Y-cable.

The wireless and wired modes cannot work

simultaneously. It is recommended to first

configure the wireless settings of an xCAM using

wired mode. After configuration, disconnect the

wire and power, and power on the xCAM again.

Then, it will be ready for wireless operation.

c. Check and make sure that the Power LED is on.

. Click "Next" button. The Touch Panel will start adding the xCAM.

8. Click "Accept" button.

9. Click "Next" button.

10. Enter the required data for the device. Click "Next".

11. Adjust the xCAM, if required. Click "Next".

12. Click "Verify Camera" button. Then click "Next".

13. Click on "Cameras" on the main screen.

14. Now you can see the live stream in the touch panel. Setup is now complete.

15. Unplug the Y-cable and power off the xCAM. Now the xCAM is ready to be placed at a

desired location, and can operate under wireless mode.