User's Manual
6103Y
SNMP Targets
Cisco Small Business WAP121 and WAP321 Wireless-N Access Point with PoE 84
REVIEW DRAFT Version 2—CISCO CONFIDENTIAL
• $XWKHQWLFDWLRQ.H\—(If you specify MD5 as the authentication type) A
password to enable the SNMP agent to authenticate requests sent by the
user.
The password must be between 8 and 32 characters in length.
• (QFU\SWLRQ7\SH—The type of privacy to use on SNMP requests from the
user, which can be one of the following:
- '(6—Use DES encryption on SNMPv3 requests from the user.
- 1RQH—SNMPv3 requests from this user require no privacy.
• (QFU\SWLRQ.H\—(If you specify DES as the privacy type) A key to use to
encrypt the SNMP requests.
The key must be between 8 and 32 characters in length.
67(3 Click $GG, and then click 6DYH. The user is added to the SNMPv3 Users list and
your changes are saved to the Running Configuration and to the Startup
Configuration.
127( To remove a user, select the user in the list and click 5HPRYH.
61037DUJHWV
SNMPv3 targets send trap messages to the SNMP manager. Inform messages are
not supported. Each target is defined with a target IP address, UDP port, and
SNMPv3 user name.
127( SNMPv3 user configuration (see 61038VHUVSDJH) should be completed
before configuring SNMPv3 targets.
127( The AP supports a maximum of eight targets.
To add SNMP targets:
67(3 Click 6103Y > 7DUJHWV in the navigation window.
67(3 Configure the parameters:
• ,3Y,3Y$GGUHVV—Enter the IP address of the remote SNMP manager to
receive the target.