User Manual

2
 Tamper Mode: The device will beep once a minute and the yellow LED is steadily on until the device is mounted back to the
bracket properly.
Intallation
Battery Installation/Replacement
1. Press the transparent locker of the device and remove the battery cover.
2. Install the supplied three AA batteries correctly.
3. Attach the battery cover to the device.
Note: The battery cover cannot be closed if the three AA batteries are not installed properly.
4. The device will beep and all the LEDs will flash for about 0.5 second after batteries are properly installed.
Recommended Battery Type
Please use the following suggested battery. Use of a different battery may cause a detrimental effect on alarm operation.
 AA 1.5V Energizer # E91 Alkaline battery
 AA 1.5V Energizer #L91 lithium battery
Locations to install your SZ-COD01
The suggested location for installing the device is in or near sleeping areas of your home. For maximum protection, the
SZ-COD01 should be located outside primary sleeping areas or on each level of your home.
Do not place the device in the following areas:
 Where the temperature may drop below 40(4.4℃) or exceed 100℉ (37.8℃)
 Near paint thinner fumes
 Within 5 feet (1.5 meter) of open flame appliances such as furnaces, stoves and fireplaces
 In exhaust streams from gas engines, vents, flues or chimneys