RP131 Wireless PoE Adapter Installation Guide Ver.1.
Overview The RP131 (Wireless Adapter) is Wireless client with power supply, it supply the power to the IP camera, it also connect the IP camera to your existing Wireless network.
Physical Details Figure 1: RP131(Wireless PoE Adapter) Page 2
LEDs Power (Green) On - Normal operation. Wireless/ WPS Green Off - No power. On - Associate to WiFi AP Off - Not associate to WiFi AP Flashing - Transmitting/Receiving Data Amber On - WPS failed (30 sec) Off - No WPS action or WPS Succeed Flashing - WPS is processing (< 2 min) Ethernet (Green) On - Ethernet connection is active. Off - No Ethernet connection. Flashing - Data is being transmitted or received via the Ethernet Port.
Buttons WPS Button Establish a secure connection between the Wireless router (or Access Point) and IP camera Push-Button-Method Press and hold the WPS button, but not no more than 3 seconds PIN Method Press the WPS button and hold for greater than 3 seconds LAN Port Use a standard LAN cable to connect the RP131 to the IP Camera Page 4
The installation allows the RP131 to directly connect to a wireless router (or Wireless Access Point). You can extend the range of your wireless network.
1. Locate the RP131 near the Wireless Access Point while doing the configuration. 2. Make sure the Wireless Access Point is on and working properly. 3. Plug the RP131 into the AC power slot, then the Power LED will remain on. 4. Plug the IP camera into the AC power slot 5. Connect a standard LAN cable from the RP131 to IP camera 6. Push the WPS button on the Wireless Access Point and make sure the Wireless Access Point is in WPS mode. (The LED on the AP will blink and active for 2 minutes.) 7.
Dimensions 91.7(L) x 57(W) x 56.9 61.2(H) mm Wireless Standards IEEE 802.11 b/g/n Antenna Internal x 2 LEDs 1 * Power 1 * Wireless / WPS 1 * Ethernet 1 * PoE PoE IEEE802.3 af Class 3 Maximum outpout power : 10 Watts DC 48V, 208mA(maximum) Over current protection Data pin : 1, 2, 3, 6 Power pin : 4, 5, 7, 8 Ethernet Interface 1 * RJ45 LAN Port Auto-negotiation, Auto MDI/MDIX Ethernet Standards Ethernet specification IEEE802.3, IEEE802.3u, IEEE802.
Humidity Certifications FCC Part 15 Class B Safety Approvals UL Listed (UL60950-1)/cUL CSA No.
FCC Information to User FCC Information to User This device complies with part 15 FCC rules. Operation is subject to the following two conditions: This withharmful part 15interference FCC rules. (1)thisdevice device complies may not cause (2)this device must accept any interference received, including interference that Operation is subject to the following two conditions: may cause undesired operations.
