IEEE802.11n 2.
Contents User's Guide .......................................................................................................................... 1 Getting Started ...................................................................................................................... 3 Initial Setup........................................................................................................................ 3 Getting to Know Your Universal Wireless Reapter.............................................
Getting Started Initial Setup To get started, you will need: Your primary wireless router, its network name (SSID), and password. A personal computer with a web browser Step 1: Connect the cable to the Ethernet port on your PC, and then plug in the power supply. Step 2: Open a browser, visit http://192.168.0.
instructions. Step 3: Once the RP101 has successfully joined the wireless network, disconnect it from the PC, and unplug the RP101. Step 4: Place the RP101 in an area where you can still access your wireless network without problems, but close to the area where you want to establish your extended network. Step5: Press power on botton. Step 6: Join your new extended wireless network.
Getting to Know Your Universal Wireless Reapter Top Panel
Label color Behavior Slow Description Flashing System Booting Amber Power LED Solid Amber System Failure Solid Green System operationa Green/Amber Flash Amber & (When Amber on then Green off, Amber off Green then Green on) System upgrade in process Solid Green (2 minutes) WPS started Slow Flashing (ON for 0.5 sec and OFF for 0.5 sec.) WPS Green activities Quick Flashing (ON for 0.1 sec and OFF for 0.1 sec.
Label color Behavior Description Client(s) connected and the data rate 100-75 Mbps Green+Red(Yellow) (N mode) 24-36Mbps(non-N mode) Client(s) connected and the data rate < 75Mbps Red (N mode) < 24Mbps (non- N mode) Solid Green Ethernet LED Green 10/100Mbps Link detected Fast Flashing Green Receing/transmitting datat at 10/100Mbps Off No Ethernet conneciton
Side Panel A) Wi‐Fi Protected Setup (WPS) Button The WPS button on the front of your RP101 can be used to help establish a secure connection between your RP101 and other WPS‐enabled Wi‐Fi devices such as computers. B) Reset Button This button is used to restart your RP101 in rare cases when it functions incorrectly. Resetting the RP101 will preserve your settings. This button may also be used to restore the factory default settings. C) Device On/Off button Turns the device on and off.
Technical Details System Requirements 802.11a/b/g/n 2.4GHz and/or 5GHz wireless router with broadband Internet connection At least one computer with: Installed wireless network interface card and TCP/IP protocol Windows® XP 32 (SP3 or greater), Windows Vista® 32/64, or Windows 7 32/64; or Mac OS® X v10.5 or 10.6 Internet Explorer® v7 or above, Firefox®, Google Chrome™, or Safari® Minimum 1.
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
