Product Info

Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator & your body.
This module is intended for OEM integrators only. Per FCC KDB 996369 D03 OEM Manual v01
guidance, the following conditions must be strictly followed when using this certified module:
This module has been tested for compliance to FCC Part 15C
The module is tested for standalone mobile RF exposure use condition. Any other usage conditions
such as co-location with other transmitter(s) or being used in a portable condition will need a
separate reassessment through a class II permissive change application or new certification.
This equipment complies with FCC mobile radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with a minimum distance of 20cm
between the radiator & your body. If the module is installed in a portable host, a separate SAR
evaluation is required to confirm compliance with relevant FCC portable RF exposure rules.
The following antennas have been certified for use with this module; antennas of the same type
with equal or lower gain may also be used with this module.
The antenna must be installed such that 20 cm can be maintained between the antenna and users,
and the maximum antenna gain allowed for use with this device is -1.4dBi for LoRa, Monopole
antenna and 0.1dBi for Bluetooth, PIFA antenna.
The final end product must be labeled in a visible area with the following: “Contains FCC ID:
P27RCM0”. The grantee's FCC ID can be used only when all FCC compliance requirements are met.
This transmitter is tested in a standalone mobile RF exposure condition and any co-located or
simultaneous transmission with other transmitter(s) or portable use will require a separate class II
permissive change re-evaluation or new certification.
This transmitter module is tested as a subsystem and its certification does not cover the FCC Part
15 Subpart B (unintentional radiator) rule requirement applicable to the final host. The final host
will still need to be reassessed for compliance to this portion of rule requirements if applicable.
As long as all conditions above are met, further transmitter test will not be required. However, the