User's Manual

6
For this Model, it will disable the Wireless Interface. The
Wireless and LAN interfaces cannot be used simultaneously.
Using the LAN interface is recommended for initial
configuration. After the Wireless settings are correct, the
Wireless interface can be used.
The first time you connect to the camera, you should connect
the RJ-45 USB cable and configure the WiFi IP Camera with
appropriate settings. Then you can unplug the RJ-45 USB
cable and power off the camera. The WiFi IP Camera will be in
wireless interface when you power on the camera again.
3. Power Up
Connect the supplied 12Vpower adapter to the WiFi IP Camera and power up. Use only
the power adapter provided. Using a different one may cause hardware damage.
4. Check the LEDs
 The Power LED will turn on briefly, then start blinking. It will blink during startup, which
will take 55 to 57 seconds. After startup is completed, the Power LED should remain ON.
 The Network/WPS LED should be ON.