User's Manual

5
Network/WPS LED
(Green, Amber)
On (Green) - Network (Wireless or LAN) connection is available.
Off - Wireless or LAN is not connected or camera is not
sending/receiving data.
Blinking (Green) - Data is being transmitted or received via the
LAN or Wireless connection.
On (Amber) - If the LED is on for 5 seconds and then off, the WPS
function is failed.
Blinking (Amber) - WPS function is being processed.
Power LED
(Green)
On - Power on.
Off - No power.
Blinking - The Power LED will blink during start up. This will take
55 to 57 seconds.
LAN port
Use the provided RJ-45 USB cable to connect your Wireless IP
Camera to a 10/100BaseT hub or switch.
Note:
 Plugging in the LAN cable will disable the Wireless interface.
Only 1 interface can be active at any time.
 The RJ-45 USB cable should only be connected or disconnected
when the camera is powered OFF. Attaching or detaching the
RJ-45 USB cable while the camera is powered on does NOT
switch the interface between wired and wireless.
DC Power Input
Connect the supplied 12V power adapter here. Do not use other
power adapters; doing so may damage the camera.
WPS/Reset Button
Push the WPS button on the device and on your other wireless
device to perform WPS function that easily creates an encryption-
secured wireless connection automatically.
 WPS PBC Mode. When pressed and released (less then 3
seconds), the Wireless IP Camera will be in the WPS PBC
mode (Auto link mode).
 WPS Pin Code Mode. When pressed and held for over 3
seconds, the Wireless IP Camera will be in the WPS Pin Code
mode.
 Reset to manufacturer default valued and reboot. When
pressed and held over 10 seconds, the settings of Wireless IP
Camera will be set to their default values.
Package Contents
The following items should be included: If any of these items are damaged or missing, please
contact your dealer immediately.
1. Wireless IP Camera x 1
2. Wall-Stand x 1
3. DC power adapter x 1
4. Camera mount kit
5. USB to Ethernet cable x 1