User's Manual

Chapter 2

Basic Setup

This Chapter provides details of installing and configuring the

Network Camera.

System Requirements

• To use the wired LAN interface, a standard 10/100BaseT hub or switch and

network cable is required.

• To use the Wireless interface on the wireless model, other Wireless devices

must be compliant with the IEEE802.11b, IEEE802.11g or IEEE 802.11n

specifications. All Wireless stations must use compatible settings.

The default Wireless settings are:

Mode: Infrastructure

SSID: ANY

Wireless Security: Disabled

Domain: USA

Channel No.: Auto

Installation - Network Camera

1. Assemble the Camera

On the Wireless Model, screw the supplied antenna to the mounting point on the

rear.

2. Connect the LAN Cable

Connect the Network Camera to a 10/100BaseT hub or switch, using a standard

LAN cable.

For this Model, it will disable the Wireless Interface. The

Wireless and LAN interfaces cannot be used simultaneously.

Using the LAN interface is recommended for initial

configuration. After the Wireless settings are correct, the

Wireless interface can be used.

The first time you connect to the camera, you should connect

the LAN cable and configure the Network Camera with

appropriate settings. Then you can unplug the LAN cable and

power off the camera. The Network Camera will be in wireless

interface when you power on the camera again.