User's Manual

Chapter 2

Basic Setup

This Chapter provides details of installing and configuring the Wireless

Network HD Camera.

System Requirements

 To use the wired LAN interface, a standard 10/100BaseT hub or switch and network cable

is required.

 To use the Wireless interface on the wireless model, other Wireless devices must be

compliant with the IEEE802.11b, IEEE802.11g or IEEE 802.11n specifications. All

Wireless stations must use compatible settings.

The default Wireless settings are:

Mode: Infrastructure

SSID: ANY

Wireless Security: Disabled

Domain: USA

Channel No.: Auto

Installation - Wireless Network HD Camera

1. Assemble the Camera

Attach the Camera Stand to the camera.

2. Connect the RJ-45 Cable

Connect the Wireless Network HD Camera to a 10/100BaseT hub or switch, using the

supplied

RJ-45 cable.

For this Model, it will disable the Wireless Interface. The

Wireless and LAN interfaces cannot be used simultaneously.

Using the LAN interface is recommended for initial

configuration. After the Wireless settings are correct, the

Wireless interface can be used.

The first time you connect to the camera, you should connect

the RJ-45 cable and configure the Wireless Network HD

Camera with appropriate settings. Then you can unplug the

RJ-45 cable and power off the camera. The Wireless Network

HD Camera will be in wireless interface when you power on

the camera again.