User's Manual

Trigger Event

Check to perform all of the event(s) that were configured and

scheduled.

Interval

Select the desired option for the events interval. (* "0" = No Delay)

Enable Motion

Detection..

If enabled, movement in a motion detection window can be used to

trigger events.

Disable Pan/Tilt..

This option is only available if your camera is fitted with a Pan/Tilt

control. If available, select the desired option to resolve conflict

between the Pan/Tilt and Motion Detection features.

Disable Motion

Detection while..

If the checkbox is enabled, wrong movement in a motion detection

window can not be used to trigger events.

But if you enable the checkbox of Go to Motion Detection position if

idle and select the idle time, it will be used to trigger events.

Trigger by

• Input - This describes the states that the input must be in for an

event to be triggered. Only one input can be used, also note that

the states for the input used must first be reached before the

event will be triggered.

• PIR - If the PIR sensor detects a human body, it will be used to

trigger events.

• Motion Detection - Movement in a motion detection window

can be used to trigger events.

Actions

• E-Mail - If checked, an E-Mail (with "Attachment") will be

delivered to the SMTP server. (SMTP Server must be

configured on the E-Mail page.)

• FTP - If checked, an FTP upload will be activated to the FTP

server. (FTP servers must be configured on the FTP page.)

• Output Port - If checked, the output port state will be activated

as configured. (Output port must first be configured on the I/O

Port page.)

• HTTP - If checked, an Instant Messaging (IM) will be delivered

to the Jabber server. (Jabber server must be configured on the

Instant Messaging page.)

• White LED - If checked, the white LEDs will only be turned on

for certain period of time when the surrounding light is under

0.5 lux. You can configure the time in the White LED Delay

Time field below.

• SMB - If checked, JPEG image(s) or video files will be

uploaded to the SMB server. (SMB must first be enabled and

configured on the SMB Client page.)