User's Manual

19
Speaker On. This icon is displayed if speaker is On. Click on the icon to
turn speaker Off.
Volume. If audio is enabled, use this slider to adjust the volume.
Setup. Select the desired video format from the drop-down list.
ON. Click this to set the output I/O port to ON mode.
OFF. Click this to set the output I/O port to OFF mode.
LED ON. Click this to turn on the White LEDs.
LED OFF. Click this to turn off the White LEDs.
Camera Patrol. Move through the Preset positions in the sequence defined
by the Camera Administrator.
Camera Auto Pan. Click this to have the camera moved from left to right
automatically.
Motion Detection. Click this button to have the camera moved to the
Motion Detection Preset position.
Direct P/T. Use this to move the camera to the Pan/Tilt position directly.
Preset Points. Select the desired Preset points.
Move Control. Use this to move the camera to the desired position. There
may a short delay after clicking the desired icon. You should wait a couple
of seconds rather than click again.
Or you can drag the vertical or horizontal slider bar to have quicker
movement of the Network Camera to the desired position.