User Manual

4
4. Reset
This button has two (2) functions:
• Reboot. When pressed briefly and released, the Network
Camera will reboot (restart) itself.
• Reset to Factory Default. To reset to factory defaults:
1. Power On
until Camera’s Power and Network LED are static
on.
2. Keep holding the Reset Button down for 10 seconds, then
release,
Camera will return to factory default setting.
5. Microphone
The built-in microphone is located on the rear of the device.
6. Power Indicator
(Green)
On - Power is on.
Off - Power is off.
Flashing -
The Power LED blinks during power up. This can take
about 60~90 seconds.
7. Network /WPS
Indicator (Green/
Amber)
On (Green) - LAN/Wireless connection established.
Off - No active connection on the corresponding LAN port, or not
associated to Wireless AP.
Flashing (Green) - Data is being transmitted or received.
On (Amber) - If the WPS association fails, the WPS LED will be
on continuously for 5 seconds.
Flashing (Amber) - WPS association is in process. The LED goes
off when the connection is complete.