User Manual

12
Ceiling Mounting
1. Disassemble the Iron plate
a. Screw the swivel connector off the stand. Then use the screwdriver to remove the
screw of the stand base.
b. Disassemble the iron plate from the bottom of the stand.
2. Install Mount Screws
a. Place the iron plate in the desired position of the ceiling. Screw two M4 self-taping
screws into ceiling through the 2 round holes of the iron plate.
3. Mount the Network Camera
a. Use the screwdriver to tighten the screw of the stand base.
b. Attach the swivel connector to the base by turning clockwise.
c. Attach the Network Camera to the swivel connector by turning it clockwise.