User's Manual

Set up of Waterproof HD IP Camera

1. Assemble the Camera

Attach the Camera Stand to the camera.

Note: Due to the wide angle IR illumination and over exposure engine algorithm,

please make sure that field of view produced by the camera doesn't cover the

foreground object, such as table top or side wall. It is recommended to place the

camera close to the edge of table top or tilt the camera away from side wall, to get

the best video quality of the target at night.

2. Internet Connection

 Wire Connection

Connect the Camera to a 10/100BaseT hub or switch, using a RJ-45

USB cable (optional) and a standard LAN cable.

For this Model, it will disable the Wireless Interface. The

Wireless and LAN interfaces cannot be used

simultaneously. Using the LAN interface is

recommended for initial configuration. After the Wireless

settings are correct, the Wireless interface can be used.

The first time you connect to the camera, you should

connect the RJ-45 USB cable and configure the Wireless

IP Camera with appropriate settings. Then you can

unplug the RJ-45 USB cable and power off the camera.

The Wireless IP Camera will be in wireless interface

when you power on the camera again.