User's Manual

4
Rear Panel - Waterproof HD IP Camera
Figure 3: Rear Panel
1. DC Power Input
Connect the supplied 12V/1.5A power
adapter here. Do not use other power
adapters; doing so may damage the camera.
2. WPS/Reset Button
This button has two functions:
1. WPS. Push the WPS button on the
device and on your other wireless device
to perform WPS function that easily
creates an encryption-secured wireless
connection automatically.
 WPS Pin Code Mode. When pressed
and held for 3-10 seconds, the
Waterproof HD IP Camera will be in
the WPS Pin Code mode.
2. Reset to manufacturer default valued
and reboot. When pressed and held
over 10 seconds, the settings of Network
Camera will be set to their default
values.
3. Power LED
(Green, Amber)
On (Green) - Power on.
Off - No power.
Blinking (Green) - The Power LED will blink
during start up. This will take 55 to 57
seconds.
On (Amber) - Firmware upgrade is failed.
Blinking (Amber) - The firmware is
upgrading.