NA403 Home Monitoring Gateway User Guide
Table of Contents CHAPTER 1 INTRODUCTION ............................................................................................. 1 Package Contents .............................................................................................................. 1 Features .............................................................................................................................. 1 LEDs ......................................................................................................
Chapter 1 Introduction 1 This Chapter provides an overview of the Home Monitoring Gateway's features and capabilities. Congratulations on the purchase of your new Home Monitoring Gateway. The Home Monitoring Gateway is a consumer electronic device, which is used for home monitoring and security.
LEDs Front-mounted LEDs The Home Monitoring Gateway has 8 LEDs. POWER ETH (1~2) (Green) WiFi Zigbee USB (1~2) Service • On (Green)- Power On • Off - Power Off • On (Amber) - POST (power on self test) failure or device malfunction • On (Green)- LAN connection established. • Off - No active connection on the corresponding LAN port. • Flashing - Data is being transmitted or received via the corresponding LAN (hub) port.
Rear Panel Reset This button has two (2) functions: • Reboot. When pressed and released, the Home Monitoring Gateway will reboot (restart). • Clear All Data. This button can also be used to clear ALL data and restore ALL settings to the factory default values. To Clear All Data and restore the factory default values: 1. Power On. 2. Keep holding the Reset Button down for 8 seconds. Release the Reset Button. The Home Monitoring Gateway is now using the factory default values.
Chapter 2 Initial Installation 2 This Chapter covers the software installation of the Home Monitoring Gateway. Requirements • Network cables. Use standard 10/100BaseT network (UTP) cables with RJ45 connectors. Procedure 1. Choose an Installation Site Select a suitable place to install the Home Monitoring Gateway. 2. Connect LAN Cables Use standard LAN cables to connect devices to the Ethernet ports on the Home Monitoring Gateway. 4.
Initial Installation • The ETH LED should be ON (provided the PC is also ON.
Chapter 3 Board Description 3 This Chapter provides board description for the Home Monitoring Gateway. Overview NA403 is a home gateway/automation, monitoring platform based on the Broadcom chip BCM5354. Below is an image of the board showing different connection and interfaces. Components and connectors 1. Power connector - The power jack connects to DC12V 1A power source. 2. Console connector - The RS232 connector is used for debugging purpose. Note interface voltage level is CMOS (3.
6. WLAN antenna - This is he antenna for wireless LAN. 7. USB connector - The two connectors are USB hosts with support for mass storage devices. Currently, there is no auto detection for plugged in devices; the devices will need to be manually mounted. 8. Zigbee module - this is a Zigbee static controller which can monitor/control other Zigbee based devices/sensors. 9. Push button 1 - this push button’s state is accessible via GPIO pin 4.
Console port connection guide For platform debugging, please locate the console cable accompanied with the development kit.
Router/AP configuration To configure the gateway settings for the NA403, the user simply connects the host to the LAN port. Then using Internet Explorer connect to the URL http://192.168.1.1 The default user name and password is: User name: (blank) Password: admin The image below shows the configuration page once the user has entered the correct username and password.
Regulatory Approvals FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
